PCB-assembly
Contents
HALT! STOP!
Are you starting to assemble a kit bought not directly from schalltechnik_04.de? If yes, check every part again the list of parts.
Really! E.V.E.R.Y. Part!
If anything is wrong -> contact your seller!
If you’re not certain, if it is the correct part -> contact us.
It’s 10 mins invested, that will later safe you headaches.
HALT! STOP!
With that out of the way, let’s start building. 🙂 First we start with the bare PCB and start with the first component.
Insert 1N4148 diodes (4x) and solder them. Align correctly!
Sometimes the marking on the silkscreen isn’t very good to see.
Luckily the land has different shapes. The Cathode (the side with marking) comes in the hole with the square land. (see picture above)
Insert 220R resistors (2x) and solder them.
Insert 1k resistors (2x) and solder them.
Insert 3.3k resistor (1x) and solder it.
Insert 22k resistors (2x) and solder them.
Insert 100k resistor (1x) and solder it.
Insert 1M resistor (1x) and solder it.
Insert 1N5819 diode (1x) and solder it. Align correctly!
Insert the 8 Pin DIL-Socket (1x) and solder it. Align correctly!
Insert 47pF capacitor (1x) and solder it.
Insert 10nF (10nX###) capacitor (1x) and solder it.
Insert 22nF (22nX###) capacitor (1x) and solder it.
Insert 100nF (.1X###) capacitor (1x) and solder it.
Insert 10µF capacitors (3x) and solder them. Align correctly!
The pads are quite near to each other. Don’t accidentally bridge them!