Parts
Contents
To assemble the pcb the following parts are needed:
[table caption=”resistors
– (all 0207, 1% metalfilm)” width=”150″ colwidth=”50|10″ colalign=”left|left”]
quantity| type
9x|1k
4x|3.3k
3x|4.7k
10x|10k
4x|47k
5x|100k
3x|470k
4x|1M
1x|1M (SMD 1206)
[/table][table caption=”capacitors” width=”420″ colwidth=”50|370″ colalign=”left|left”]
quantity| type
7x|47pF (RM2.5mm, MLCC)
2x|22nF (0.022µF) (spacing 5.0mm, film)
1x|47nF (0.047µF) (spacing 5.0mm, film)
9x|100nF (0.1µF) (spacing 5.0mm, film)
2x|220nF (0.22µF) (spacing 5.0mm, film)
7x|10µF (spacing 2.5mm, max-Ø5.0mm, electrolytic)
6x|100µF (spacing 2.5mm, max-Ø6.3mm, electrolytic)
1x|220µF (spacing 3.5mm, max-Ø8.0mm, electrolytic)
[/table][table caption=”inductors” width=”420″ colwidth=”50|370″ colalign=”left|left”]
Anzahl| Typ
2x|1mH (100 mA, 11.5 Ohm, spacing 2.0mm -> RLB0608-102KL)
1x|2.2mH (85 mA, 20.0 Ohm, spacing 2.0mm -> RLB0608-222KL)
[/table][table caption=”semiconductors” width=”320″ colwidth=”50|270|” colalign=”left|left”]
quantity| type
2x|1N5817
1x|BC547B
1x|78L05
1x|3mm LED green
1x|3mm LED red
3x|TL074
1x|TC7662B
[/table][table caption=”mechanical” width=”450″ colwidth=”50|400″ colalign=”left|left”]
quantity| type
1x|dc-jack print
5x|NMJ6HCD2 stereo jack
4x|16/17mm pot angled print 50kB (lin)
2x|16/17mm pot angled print 2x50kC (rev log)
1x|print pot 50kB (lin)
1x|trim pot 50kB (lin) 5mm/5mm
2x|rotary switch, 4 poles, 3 positions, non-shorting, print
5x|pcb switch latching dpdt with caps
1x|FRT5 DC5V, Takamisawa A-5W-K or Zettler AZ850-5 Relay
2x|footswitch (small, DPDT)
2x|washer for footswitch
1x|DIL08 socket
3x|DIL14 socket
1x|cable tie 100×2,5mm
10x|wires – 10cm each
[/table]
misc:
- PCB-cleaner
- insulating-tape
- solder
- tools
- soldering iron,
- side cutter,
- round nose pliers/tweezers,
- desoldering pump/-braid,
- screw drivers,
- a set of socket spanners or a wrench